Perform injection quantity compensation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
If the DDE control unit or an injector has been replaced, it will also be necessary to carry out injection quantity compensation. The adjustment value for the injection quantity compensation is printed on each injector. The adjustment value must be read off before installation.
If the DDE control unit or an injector has been replaced, it will also be necessary to carry out injection quantity compensation. The adjustment value for the injection quantity compensation is printed on each injector. The adjustment value must be read off before installation.
- Connect diagnostic system.
- Vehicle handling
- Service functions
- Engine electronics
- Adjustment programs
- Injection quantity compensation
- Enter adjustment value.
For each replaced injector, the adjustment value must be entered according to the installation location (cylinder).