Moving the crankshaft into the installation position of cylinder bank 1

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Turn the engine at the central bolt in clockwise direction until the installation position (MP) (1) of the vibration absorber (1) is positioned flush with the marks of the engine block.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the camshaft positions of cylinder bank 1.
The cams (1) should be in the position shown.

The increment wheels (2) should each form a straight line with the exhaust camshaft bearing cap and the intake camshaft bearing cap.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Description is for right component only. The procedure on the left side is identical.

NOTE: To provide a better overview: Schematic diagram with partially hidden components.
Ensure that the polished surfaces of the camshafts (1) point upward.

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure that the rounded surfaces (1) are pointing down to the cylinder head.
Check timing again and assess.