Installing the left Valvetronic servomotor (cylinder head removed)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.
The work must be performed with vehicle care to prevent component damage.
- If necessary, lever the radial shaft seal (1)
out of the cylinder head using a commercially available tool.
- Replace radial shaft seal (1)
at front.
Parts: Radial shaft seal
- Grease the gearing on the worm drive in area (2)
using lubricating grease.
Parts: lubric. grease
CONSUMABLE SPECIFICATIONLubricating grease Longtime PD-1 400 g, Cartridge 83192160340 - Screw in the Valvetronic servomotor (1) evenly with the shaft (2) through the gearing of worm drive up to the stop.
- Secure screws (3) .
TIGHTENING TORQUES SPECIFICATION
| Valvetronic servomotor on cylinder head | ||
| M6x16-8.8 | Tightening torque | 9.6 Nm |