Install the holder with the vehicle wiring harness for the sensor system of cylinder bank 1

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Position the holder (2) with the wiring harness for the sensor system.
Tighten the screws (1) .

TIGHTENING TORQUES SPECIFICATION

Holder of sensor system
M6x16 screw	Tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.