LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Air Bag Restraint Systems) >> Removal & Installation >> Driver-Side Air Bag Module >> Removal & Installation (3-spoke Steering Wheel)

Removal & Installation (3-spoke Steering Wheel)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 BMW Z3, 2001 BMW M3, 2001 BMW M Roadster, 2001 BMW M Coupe, and 2001 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Insert screwdriver through opening on rear side of steering wheel. See Fig 1 . Press down on spring loaded clip and pull out air bag. See Fig 2 . Repeat process on opposite side. Pull out air bag and disconnect electrical connectors. Open locks on plugs and disconnect plug connections. Remove air bag. Put air bag module in a secure area with trim pad (air bag) facing upward.
  3. To install, insert air bag hooks into locks and press into steering wheel. Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
Fig 1: Inserting Screwdriver Behind Steering Wheel
G99C22725Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Releasing Smart Air Bag Retaining Clips
G99E22727Courtesy of BMW OF NORTH AMERICA, INC.