67 62 000 Removing and installing / replacing flat motor for front left or right power window unit

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required:

00 9 317

Necessary Preliminary Tasks:

Remove front door trim. Sse 51 41 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT DOOR TRIM PANEL

NOTE: To remove the flat motor, it is necessary to detach the acoustic insulation in the lower area only.

Lever out sealing bead (1) of acoustic insulation (2) with special tool 00 9 317.

NOTE: Work with particular care in area (A) otherwise acoustic insulation (2) will tear and must be replaced.

Fig 1: Removing Sealing Bead Of Acoustic Insulation Using Special Tool 00 9 317

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Fig 2: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2).

Installation:

Tightening torque 4.5 +/- 0.5 N.m.

Turn flat motor slightly and lift out in direction of arrow.

NOTE: Make sure door window glass has not been fully moved downwards.

Fig 3: Removing Flat Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Convertible From 09/2003:

Replacement:

A normalization must be carried out in order to activate anti-trapping protection.

Operating sequence for normalization:

Open corresponding window completely.
Press corresponding power window switch into "close one-touch operation" (second switch stage).
Once the upper end position has been reached, hold power window switch down for approx. 1 second more.

Normalization is thus completed.

NOTE: Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).