61 67 040 Adjusting spray nozzles for headlight cleaning system

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required:

NOTE: For special tools, refer to GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - 3 SERIES (E46) .

00 9 100
64 1 020

Low-Beam Headlamp:

The spray contact point must be located in the center of the low-beam headlamp.

To adjust, slowly pull out spray nozzle fully with aid of special tool 4 1 020 and adjust spray contact point with special tool 00 9 100.

Fig 1: Adjusting Spray Contact Point With Special Tool (00 9 100) Low-Beam Headlamp

Courtesy of BMW OF NORTH AMERICA, INC.

High-Beam Headlamp:

The spray contact point must be located in the center of the high-beam headlamp.

To adjust, slowly pull out spray nozzle fully with aid of special tool 64 1 020 and adjust spray contact point with special tool 00 9 100.

Fig 2: Adjusting Spray Contact Point With Special Tool (00 9 100) High-Beam Headlamp

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: After checking the contact points, turn ignition off and on again before repeating the spray procedure. The function of the headlight cleaning system is otherwise disabled for approx. 3 minutes. Refer to function description in Diagnosis and Information System.