11 36 570 Replacing solenoid valve for inlet side on VANOS adjustment unit

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: For special tools, refer to ENGINE - SPECIAL TOOLS .

32 2 110

Necessary preliminary tasks:

Read out fault memory of DME control unit
Check stored fault messages
Switch off ignition

Unlock hose (1) and detach.

Unlock plug (2) and remove.

Fig 1: Unlocking Hose And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Once it has been removed, oil drips from the solenoid valve.

Have a cleaning cloth ready.

Make sure no oil drips onto the belt drive. Remove any remnants of oil immediately with cleaning cloth.

Do not damage oil line when releasing solenoid valve.

Release solenoid valve with special tool 32 2 110.

Fig 2: Releasing Solenoid Valve With Special Tool 32 2 110

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tightening torque, refer to 11 36 1AZ in ENGINE - TIGHTENING TORQUES .

Now clear the fault memory.