51 13 402 Removing And Installing Handle Strip (On Trunk Lid)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Version From 10/99:
Remove panel for rear lid in rear area. Refer to 51 49 000 REMOVING AND INSTALLING OR REPLACING TRIM FOR TRUNK LID .
Feed out wiring harness (2) in direction of arrow from bracket (1).
Disconnect plug connection (3).
Release screws (1) and withdraw handle strip (2) somewhat.
Version from 10/99:
Remove strip handle (2).
Installation:
Tightening torque, refer to 51 13 4AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 3-SERIES .
Check function.
Version up to 10/99:
Disconnect plug connection (1) and remove handle strip (2).
Installation:
Tightening torque, refer to 51 13 4AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 3-SERIES .
Check function.