51 16 060 Removing And Installing/Replacing Interior Rearview Mirror (With Rain Sensor)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Version With Remote Control For Central Locking:

If necessary, disconnect negative lead from battery. Refer to 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .

Version With Compass:

Check compass function if replacing or after disconnecting interior mirror plug connection or battery.

If necessary, calibrate compass in interior rearview mirror.

Security Version:

Rain sensor is not installed, cable connection is tied back in roofliner.

IMPORTANT: Do not snap out the interior rearview mirror (1) towards the rear (windscreen breakage). Do not under any circumstances twist the interior rearview mirror when removing. Twisting the mirror off the mirror mount will damage the rear catch. If the rear catch is damaged, the mirror will be loose when installed and must be replaced.

IMPORTANT: Do not snap out the interior rearview mirror (1) towards the rear (windscreen breakage).

Press on end caps (1) and at same time press them apart; this releases clip connection of both caps (1).

Fig 1: Pressing On End Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Twist mirror (1) at an angle towards front and right/top.

Swivel left end cap (2) off ball neck in direction of arrow; this detaches the engagement clip (3) from the metal foot.

Fig 2: Twisting Mirror At An Angle Towards Front And Right/Top

Courtesy of BMW OF NORTH AMERICA, INC.

Twist mirror (1) at an angle towards front and left/top.

Swivel right end cap (2) off ball neck in direction of arrow; this detaches the engagement clip from the metal foot.

Fig 3: Twisting Mirror At An Angle Towards Front And Left/Top

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) and retaining hooks (2) of end caps (3) must not be damaged, replace if necessary.

Fig 4: Checking Clips And Retaining Hooks Of End Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

NOTE:

Pay attention to cable guide (2) for rain sensor.

Security Version:

Rain sensor is not installed, cable connection is tied back in roofliner.

Fig 5: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not remove interior mirror (1) towards rear or by twisting (risk of damage). When snapping out, do not damage control unit (3) for rain sensor. Security Version: Rain Sensor is not installed.

Snap out interior mirror (1) from mirror mount (2) towards front by striking with ball of thumb and remove.

Fig 6: Identifying Damage Control Unit For Rain Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Twist mirror foot by approx. 45° and fit to mirror mount.
Turn mirror foot until it engages on mirror base.

Fig 7: Turning Mirror Foot

Courtesy of BMW OF NORTH AMERICA, INC.

Only Replace With Version With Remote Control For Central Locking:

Initialize all transmitters (ignition keys), refer to Owner's Handbook.