LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Body Equipment - Repair) >> Bumper Strip >> 51 15 300 Removing And Installing/Replacing Protective Strip In Side Panel, Front Left Or Right (Coupe)

51 15 300 Removing And Installing/Replacing Protective Strip In Side Panel, Front Left Or Right (Coupe)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Front clip (1) is attached to protective strip (2) and cannot be replaced.

Unclip front clip (1) with special tool 00 9 317 (trim panel wedge).

Then unclip clips (3) and remove protective strip (2).

Fig 1: Locating Protective Strip Clips
G03118836Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Always replace front grommet (1) (leaks).
  2. If necessary, lever out clips or rubber grommet (2) from side panel.
    Fig 2: Identifying Front Grommet
    G03118837Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. If necessary, replace faulty rubber grommets (1) and clips (2).
  2. Attach clips with rubber grommet to protective strip and align.
  3. Replace protective strip (4) if clip (3) is damaged.

Clip protective strip into door.

Fig 3: View Of Rubber Grommets
G03118838Courtesy of BMW OF NORTH AMERICA, INC.