Steering Lock: Installation
WARNING: This page does not describe the selected car, but rather 61 other vehicles, including the 2002 BMW Z3, 2002 BMW M Roadster, 2002 BMW M Coupe, 2001 BMW Z3, and 2001 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Dowel pin must fit in bore. See Fig 1 .
- Tighten Torx screws until they shear off. See Figure .
- Fit bush (2). Fit snap ring (1) with special tool (32 1 090) and steering wheel retaining screw until it engages in groove of steering spindle. Snap ring (1) can also be mounted using special tool (32 3 070). See Fig 2 .
- Lock headless screws with varnish.
- Guide both holders of upper section into bores. See Fig 3 .
- Check for correct position of lock. On 318ti, use new shear-off screws. On all models see Fig 4 .
- Check position of collar relative to snap ring. Recess in collar locks snap ring. See Figure .
- Test lock cylinder and electric operation (e.g. ignition, radio, etc.).