LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Brakes - Repair) >> Removal & Installation >> Brake Disc >> Installation

Brake Disc: Installation

WARNING: This page does not describe the selected car, but rather 92 other vehicles, including the 2002 BMW Z3, 2002 BMW M Roadster, 2002 BMW M Coupe, 2001 BMW Z3, and 2001 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Internally ventilated brake discs are balanced. Never remove or reposition balance clips.
  1. Thoroughly clean contact surface of brake disc at wheel hub. Remove traces of corrosion if necessary. Unevenness on contact surface may result in distortion of brake disc.
  2. Install brake disc and tighten bolts to specification. See TORQUE SPECIFICATIONS .
  3. If removed, replace brake linings.
  4. Check that brake hose has not been disconnected. If disconnected make sure it is positively attached when installed.
  5. Replace caliper and tighten screws to specification. See TORQUE SPECIFICATIONS .
  6. Install wheels and bleed brakes if brake hose was disconnected. See BLEEDING BRAKE SYSTEM .
  7. If work was on rear brakes, adjust handbrake. See PARKING BRAKE  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals