52 13 050 Replacing lumbar cushion on front left or right seat

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

Carry out following tasks beforehand:

Removing rear panel on front seat backrest:

Basic seat
Sports seat

Detach backrest cover (1) from backrest frame (2).

Fig 1: Detaching Backrest Cover From Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: If necessary, gently heat air hose when firmly seated. Housing (valve block) must not be unclipped (leaks). If it is unclipped, release screw and clip housing together.

Disconnect hoses (2) and (3) from valve housing (1).

2 Hose (blue) top cushion

3 Hose (red) bottom cushion

Fig 2: Disconnecting Hoses From Valve Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Air hoses (2) and (3) must be laid without kinks.

Unhook lumbar cushion (1) from spring wire (2).

Version with seat heating:

Slide cable (3) for backrest heating to one side a little.

Fig 3: Unhooking Lumbar Cushion From Spring Wire

Courtesy of BMW OF NORTH AMERICA, INC.

Press back support (1) a little.

Turn lumbar cushion (2) and pull out downwards.

Fig 4: Pulling Lumber Support

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check lumbar cushion (1) at top and (2) bottom for damage.
Air hoses (3) must not be kinked.

Fig 5: Identifying Lumbar Cushion & Air Hoses
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Attach lumbar cushion (1) to third wire (2) above spring (3).

Fig 6: Attaching Lumbar Cushion To Third Wire Above Spring
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, shown here without valve housing.

Installation:

Observe cable guide (1) for backrest heating. Lay air hoses (2) without kinks through hole (3).

Fig 7: Identifying Cable Guide & Air Hoses
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check function.