LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Distributor Cap (V12) >> Removal & Installation (Left Cap)

Removal & Installation (Left Cap)

WARNING: This page does not describe the selected car, but rather 82 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Remove fan. Unfasten clips on air filter box. Unfasten hose clip from auxiliary hose for air pump. Disconnect electrical connection. Remove upper section of suction filter housing with mass airflow sensor. Unfasten cable connectors. See Fig 1. Unclip and remove left distributor cap cover. See Fig 2. Pull off shielded connectors. Remove screws and distributor cap. See Fig 3. To install, reverse removal procedure.

Fig 1: Unfastening Cable Connectors (V12)
G00131501Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Identifying Distributor Cap Clips (Left Cap) (V12)
G00131502Courtesy of BMW OF NORTH AMERICA, INC.
Fig 3: Removing Distributor Cap Screws (V12)
G00131503Courtesy of BMW OF NORTH AMERICA, INC.