Installing the boost pressure sensor on the intake plenum

• Check sealing ring (1) for damage, replace if necessary.
• Apply a thin coat of lubricant to the sealing ring (1) of the boost pressure sensor.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the boost pressure sensor (3).
• Tighten down screw (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Boost pressure sensor to intake plenum
  TS6X20	Tightening torque	5 Nm

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ACOUSTIC COVER .