Remove the engine oil cooler
Preliminary work
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.
The work must be performed with vehicle care to prevent component damage.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Loosen screws (1).
- Loosen screw (2).
- Drill out the rivet (1).
- Remove the damper (2).
- Loosen nuts (1).
- Disconnect the lines (2).
- Collect and dispose of emerging fluids.
- Loosen screws (1).
- Feed out the engine oil cooler (2) and remove.