Install B-pillar trim panel

• Check clips (1) for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide upper seat belt (2) into B-pillar trim panel (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert B-pillar trim panel (1) into guides (3) and under the lip of edge protection in the arrow direction.
• Clip the B-pillar trim panel in (1) with the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  End lining to body
  screw	Tightening torque	42 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the protective cap (1).

Follow-up work 

• Refer to INSTALLING REAR TRIM PANEL .
• Refer to INSTALLING THE SEAT BELT FINISHER STRIP .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
• Refer to INSTALLING BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .