Installing the trim on the right bumper cover

NOTE: Description is for left component only. Procedure on the right side is identical.

Installing the trim on the bumper panel

Install the trim (1) and snap it in at the detents (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR BUMPER COVER .
Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
Refer to INSTALLING THE LEFT AND RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (PARTIALLY REMOVED) .
Refer to INSTALLING LOADING EDGE TRIM .
Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .