Installing the control unit of the FLER
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing Frontal Light Electronics (FLEL) control unit
- Check the seal (3) for damage and, if necessary, replace it.
- Position the Front Light Electronics (FLEL) control unit (2).
- Connect connectors (1) and lock.
- Feed in the Front Light Electronics (FLEL) control unit (2) and correctly position.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Front Light Electronics control unit on headlight | ||
| Screw | tightening torque | 1.5 Nm |
Follow-up work