Install tension strut on shock tower
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
- Version A:
- Install the tension strut (3) on the shock tower.
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATION
Tension strut on firewall M10x25 screw Tightening torque 56 Nm - Replace screws (2).
Parts: Screws
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATION
Tension strut to shock tower screw Replace screws. Joining torque 56 Nm Angle of rotation 90° - Version B:
- Install tension strut (3) on the shock tower.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Tension strut on firewall M10x25 screw Tightening torque 56 Nm - Replace the screw (2).
Parts: Screw
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATION
Tension strut to shock tower screw Replace screws. Joining torque 56 Nm Angle of rotation 90°
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .