Remove right output shaft
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
NOTE:
TECHNICAL INFORMATION
The radial shaft sealing ring must be replaced each time the output shaft is removed.
The radial shaft sealing ring must be replaced each time the output shaft is removed.
Preliminary work
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING THE COVER FOR THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to RELEASING THE TIE ROD ON THE RIGHT FROM THE SWIVEL BEARING .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to RELEASING THE WISHBONE ON THE RIGHT FROM THE SWIVEL BEARING .
NOTE:
The illustration shows the procedure on the front differential. The procedure on the bearing bracket is identical.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Position the aluminum drift (2) on the output shaft (1) .
- Knock the output shaft (1)
out with the aluminum mandrel (2)
from the bearing bracket.
- Guide out the output shaft (1) in the arrow direction and remove.