Remove left output shaft
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
NOTE:
TECHNICAL INFORMATION
The radial shaft sealing ring must be replaced each time the output shaft is removed.
The radial shaft sealing ring must be replaced each time the output shaft is removed.
Preliminary work
- Refer to REMOVING THE FRONT LEFT WHEEL .
- Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to RELEASING THE TIE ROD FROM THE SWIVEL BEARING .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to RELEASING THE WISHBONE FROM THE SWIVEL BEARING .
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Position the aluminum drift (2) on the output shaft (1) .
- Knock out the output shaft (1)
with the aluminum mandrel (2)
and remove it from the front differential.
- Guide out the output shaft (1) in the arrow direction and remove.