Remove airbag unit

WARNING: Airbag unit.
Danger! Immobilization period-threatening injuries!

Before working on the airbag, disconnect the negative battery cable from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .

NOTE: RISK OF DAMAGE
Damage to the steering wheel.
Incorrect handling of the tool may damage the steering wheel.

Make sure the position (angle and inclination) of the tool is correct.
When unlocking, do not lever, but press in the Torx screwdriver only towards the center of the steering wheel.

Feel the back of the steering wheel to locate the pre-bore (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To provide a better overview: Schematic diagram with airbag unit removed.
Press the Torx screwdriver T27 (1) straight in the direction of the center of the steering wheel to unlock the wire spring (2) or to unlock the airbag unit.

Courtesy of BMW OF NORTH AMERICA, INC.
Press the Torx screwdriver T27 (1) straight in the direction of the center of the steering wheel and lift the airbag unit.
Repeat the process on the left side and carefully remove the airbag unit in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the Torx screwdriverT27 diagonally upwards in the hidden opening (1) on the rear of the steering wheel until you feel a springy resistance.
Unlock and disconnect the plug connection (1) and remove the airbag unit.

Courtesy of BMW OF NORTH AMERICA, INC.