Installing the tandem brake master cylinder
- Insert the tandem brake master cylinder (1) into the brake booster.
- Replace nuts (2)
.
Parts: Nuts
- Place and tighten nuts (2) .
TIGHTENING TORQUES SPECIFICATION
| Tandem brake master cylinder in the brake booster | ||
|---|---|---|
| Replace nuts. M8 |
tightening torque | 27 Nm |
- Fit brake lines (3) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake pipe screw connection/Union screws | ||
|---|---|---|
| tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING THE EXPANSION TANK .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .