Installing all spark plugs
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Insert spark plug (1) in the special tool 0 496 065 (12 1 230)
.NOTE: TECHNICAL INFORMATION
Do not drop the spark plug into the spark plug shaft. This can lead to a reduction of the electrode gap and can thus impair smooth running of the engine, especially in idle position. - Screw the spark plugs into the engine hand-tight with the special tool 0 496 065 (12 1 230) .
NOTE:
TECHNICAL INFORMATION
Only a swiveling extension for the reversible ratchet may be used. Rigid mounting tool and variable plug connections with rigid option may not be used; there is a risk that the insulator breaks.
Only a swiveling extension for the reversible ratchet may be used. Rigid mounting tool and variable plug connections with rigid option may not be used; there is a risk that the insulator breaks.
- Tighten the spark plugs with the torque wrench, the special tool 0 495 560 (12 1 220) and with a pivotable extension.
TIGHTENING TORQUES SPECIFICATION
| Spark plugs | ||
|---|---|---|
| M12x1.25 | Tightening torque | 23 Nm |
Follow-up work
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .