Installing the rear wheel arch trim
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check the clips (1)
for damage and replace where required.
The clips (1) must not be damaged or missing.
- Make sure that the clips (1) are always installed with the sealing ring.
- Check detents (2)
for damage.
The detents (2) must not be damaged or missing.
- Install wheel arch trim (1) and clip in with the clips (2) .
- Engage wheel arch trim (1)
on the detents (3)
.
- Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .