Installing the top air flap control/air duct
- Connect the top air flap control (3) with the appropriate connector.
- Feed in the top air flap control (3) .
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Air flap control/Brake ventilation duct | ||
|---|---|---|
| Oval-head screw | tightening torque | 4.0 Nm |
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Air flap control/Brake ventilation duct | ||
|---|---|---|
| Oval-head screw | tightening torque | 4.0 Nm |
Follow-up work
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
- Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .