Replacing the radial shaft seal for the right output shaft

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly .
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: 00 02 001 RAISING THE VEHICLE WITH A VEHICLE LIFT .

Preliminary work

Refer to REMOVING FRONT RIGHT WHEEL .
Refer to REMOVING THE COVER FOR THE STEERING ASSEMBLY ON THE RIGHT .
Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
Refer to RELEASING THE TIE ROD ON THE RIGHT FROM THE SWIVEL BEARING .
Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
Refer to RELEASING THE WISHBONE ON THE RIGHT FROM THE SWIVEL BEARING .
Refer to REMOVING RIGHT OUTPUT SHAFT .

NOTE: TECHNICAL INFORMATION
Radial shaft seal ring are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the output shaft.

NOTE: The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.

Prepare the special tool 0 490 466 (00 5 010) with the special tools 0 494 649 (21 2 230) (without the screw) and 0 493 384 (11 1 212) .

Courtesy of BMW OF NORTH AMERICA, INC.
Pull out and remove the radial shaft seal (1) with the special tools 0 490 466 (00 5 010), 0 494 649 (21 2 230) and 0 493 384 (11 1 212) .

Courtesy of BMW OF NORTH AMERICA, INC.
Replace radial shaft seal at front.
Parts: Radial shaft seal
Remove the assembly protection ring (1) from the radial shaft sealing ring (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Coat the housing of the sheet metal flange of the radial shaft seal with the approved front differential fluid.
Drive in the radial shaft seal to the stop using special tool 0 493 539 (31 5 130).
Remove the special tool 0 493 539 (31 5 130).

Courtesy of BMW OF NORTH AMERICA, INC.
Reinstall installation protection ring (1) in radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to FOR REUSING: CHECKING THE GEARING OF THE OUTPUT SHAFT AND REPLACING THE CIRCLIP .
Refer to INSTALLING RIGHT OUTPUT SHAFT .
Refer to POSITIONING THE OUTPUT SHAFT, RIGHT, AT THE SWIVEL BEARING .
Refer to PLACING THE OUTPUT SHAFT, RIGHT, TO THE SIDE .
Refer to FITTING THE WISHBONE, RIGHT, AT THE SWIVEL BEARING .
Refer to DRAINING AND TOP UP THE FRONT AXLE TRANSMISSION OIL .
Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
Refer to SECURING THE TIE ROD TO THE RIGHT ON THE SWIVEL BEARING .
Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
Refer to INSTALLING THE FRONT RIGHT WHEEL .