Move the engine to the mounting orientation
Preliminary work
- Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
- Refer to DISCONNECTING THE NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING STAND FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING ALL IGNITION COILS .
- Refer to REMOVING FUEL DELIVERY LINE .
- Refer to REMOVING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE FRONT WHEEL ARCH TRIM .
- Refer to REMOVING THE REAR SECTION OF THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
- Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to RELEASING THE WIRING HARNESS SECTION ON TO THE LEFT SPRING STRUT .
- Refer to RELEASING THE WIRING HARNESS SECTION ON TO THE RIGHT SPRING STRUT .
Prepared engine bridge
CAUTION:
Components connected to the engine joint or cross member
.
Injury hazard!
Injury hazard!
- Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
- Attach the component to correctly mounted engine joints or cross members only.
- Only lift the component, do not shift it forwards, backwards or in transverse direction.
- Carefully
position engine bridge (1)
with help from an auxiliary person.
- Make sure that special tool 0 496 438 (00 6 053) on the left lies correctly on the cross connection.
- Make sure that special tool 2 293 877 on the left is correctly positioned on the spring strut dome.
- Make sure that special tool 0 496 438 (00 6 053) on the right lies correctly on the cross connection.
- Make sure that special tool 2 293 877 on the right is correctly positioned on the spring strut dome.
- Align the engine bridge by moving it on the profile strips of the special tool above the engine mounting brackets and screw it down.
- Connect the special tool 0 490 567 (11 0020)
via the engine mounting brackets (1)
.
- Check whether the special tool 0 496 438 (00 6 053) on the right is correctly positioned on the
cross connection (1)
.
- Check whether the special tool 2 293 877 on the right is correctly positioned on the spring strut dome (1)
.
- Check whether the special tool 0 496 438 (00 6 053) on the left is correctly positioned on the cross connection (1)
.
- Check whether the special tool 2 293 877 on the left is correctly positioned on the spring strut dome (1)
.
- Keep all the standard tools ready.
Number Description 1 Standard torque wrench 2 Swivelling extension 3 External Torx E14 - Release screw (1)
of the left engine mount with standard tool (2) sideways.
- Release screw (1)
of the right
engine mount with a standard tool (2) sideways.
- Raise combustion engine by turning the special tool 2 361 506 (00 6 103)
(spindle) by 10 mm
.