Installing coolant pumps
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
- Do not use any metal-cutting tools.
NOTE:
TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.
The sealing surfaces must be free of oil, grease and cleaning agents.
- Clean sealing surfaces (1) with special tool 0 495 102 (11 4 470)
.
- Clean sealing surfaces (1) with special tool 0 495 102 (11 4 470)
.
- Replace the seal (1)
.
Parts: Seal
- Guide in and position the seal (1)
on the component carrier (2)
.
- Guide in and install the coolant pump (2) .
- Tighten down screws (1)
.TIGHTENING TORQUES SPECIFICATION
Coolant pump to component carrier M6x20 tightening torque 10.5 Nm - Tighten down screws (1)
.TIGHTENING TORQUES SPECIFICATION
Coolant pump to component carrier M6x20 Tightening torque 10.5 Nm - Tighten down screw (1)
.TIGHTENING TORQUES SPECIFICATION
Coolant pump to component earner M6x20 Tightening torque 10.5 Nm
Follow-up work
- Refer to INSTALLING THE COMPONENT CARRIER .
- Refer to INSTALLING AIR CONDITIONING COMPRESSOR .
- Refer to PARTIALLY INSTALLING AUXILIARY COOLANT PUMP .
- Refer to PARTIALLY INSTALLING THE AIR CONDITIONING CONDENSER .
- Refer to INSTALLING ALTERNATOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE CHARGE AIR DUCT FOR CYLINDERS 4-6 .
- Refer to INSTALLING THE CHARGE AIR DUCT FOR 1-3 CYLINDERS .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AIR DUCT .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to EVACUATE AND CHARGE CONDITIONING .
- Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .