Installing the front wheel speed sensor

• Clean bore for wheel RPM sensor and grease using lubricating grease (see applicable BMW parts catalogue).
  CONSUMABLE SPECIFICATION
  
  

  Lubricating grease Staburags NBU 12K

  100 g, Tube

  83 23 9 407 810

• Install rear wheel speed sensor (2).
• Position and tighten the screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front wheel speed sensor on swivel bearing
  Screw Replace screw.	Tightening torque	12 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the cable of the wheel RPM sensor in the holders (1).
• Connect the cable of the wheel RPM sensor in the holders (1).
• Connect connector and close the housing cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ATTACHING THE FRONT LEFT WHEEL .