Install the camshaft position sensor of the exhaust camshaft

• Check sealing ring (1) for damage, replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the camshaft position sensor of the exhaust camshaft (3) in and install.
• Tighten down screw (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Camshaft position sensor to cylinder head cover
  TS5x20	tightening torque	4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

Follow-up work 

• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .