Partially installing the left and right external radiator
NOTE:
Procedure shows left component only. Procedure on the right side is identical.
- Position the radiator (4) with the holder (3) diagonally downward toward the front in the rubber mounts
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Holder for upper external radiator | ||
|---|---|---|
| Screw | Tightening torque | 11.8 Nm |
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATION
| Holder for side external radiator | ||
|---|---|---|
| Screw | tightening torque | 3.5 Nm |
If installed: Installing the cross-member
- Position the cross-member (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Cross strut | ||
|---|---|---|
| Fillister head combination screw | tightening torque | 19 Nm |