Installing the vibration damper
- Clean the contact surface of the central bolt (7) .
- Align and position vibration damper for the Woodruff key of the sprocket wheel.
- Position shim (4) .
- Position fitting sleeve (2)
.
The grooves (6) of the fitting sleeve (2) must point to the counter support (5).
- Position counter support (5) .
- Tighten the screws (1)
and (3)
hand-tight.
- Replace central bolt (2)
.
Parts: Central bolt
- Treat the contact surface (1) of the central bolt (2) with lubricating grease.
CONSUMABLE SPECIFICATION
| Lubricating grease SYNTHESO GLEP 1 | 100 g, Tube | 83239407778 |
- Tighten central bolt (7) .
TIGHTENING TORQUES SPECIFICATION
| Central bolt | ||
|---|---|---|
| Screw M18x1.5x122 Replace screws. Grease screw head. |
Joining torque | 100 Nm |
| 1. Angle of rotation | 60° | |
| 2. Angle of rotation | 60° | |
| 3. Angle of rotation | 60° | |
- Release the counter support (5) and the shim (4) with the screws (1) .
- Release the fitting sleeve (2) and counter support (5) with the screw (3) .
- Remove the counter support (5) from the vibration damper.
- Remove the fitting sleeve (2) .
Follow-up work
- Refer to INSTALLING THE BELT PULLEY ON THE TORSIONAL VIBRATION DAMPER .
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .