Install the rear window
- Secure cable to rear window with adhesive tape.
- Keep 2 glue cartridges ready.
- Prepare a glue cartridge with standard nozzle C.
- Apply bead joint in area (1) .
- Apply adhesive bead (2) within the mark on the rear window
TECHNICAL DATA SPECIFICATION
| Adhesive bead | ||
|---|---|---|
| a = Position of adhesive bead to the tolerance band | 0.5 mm... 1.5 mm | |
| b = Width | 7 mm... 9 mm | |
| h = Height | 11 mm... 13 mm | |
- Open trunk lid approx. 1/3 and secure in this position.
- Carefully guide the rear window (1) in with the suction lifter parallel to the C-pillar and feed in under the tailgate.
- Carefully position the rear window (1) with the suction lifters on the top and simultaneously align it sideways.
- Carefully press the rear window (1) with the suction lifters upwards until the seal rests evenly on the roof.
- Carefully and evenly press the rear window 1 all around with the suction lifters and adjust the gap dimensions.
TECHNICAL DATA SPECIFICATION
| Gap dimension windshield to roof outer skin | ||
|---|---|---|
| 1 windshield; 2 roof outer skin | a | 4.3 +1.2-1.2 mm |
| b | 0.9 +1-1.5 mm | |
- Measure the recessed (b)
of the rear window (1)
to the roof outer skin (2)
with the special tool 0 495 259 (51 0 010)
.
Measure the gap dimension (a) with special tool 0 496 076 (00 9 470) .
- Secure rear window (1) with adhesive tap on the roof.
- Connect plug (1) .
NOTE:
Perform the steps on the right and left side.
- Connect connectors (1) and lock.
Follow-up work
- Refer to 3. INSTALLING THE BRAKE LIGHT .
- Refer to INSTALLING THE TRIM PANEL FOR THE STORAGE SHELF .
- Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING BOTH REAR SIDE TRIM PANELS .
- Refer to INSTALLING THE REAR SEAT .
- Refer to INSTALLING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .