Installing the trim strip on the A-pillar
Precondition
Front door is open.
- Carefully feed in and correctly position the trim strip on the A-pillar (2) towards the rear at the seal on the windshield panel.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Trim strip on the A-pillar | ||
|---|---|---|
| Screw | tightening torque | 1.8 Nm |
- Carefully feed the seal (1) in the trim strip on the A-pillar (2) starting from the top.
- Ensure that seal (1) is correctly seated.