Install reinforcement strut
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Feed in reinforcement strut (4) .
- Tighten down screws (3) .
TIGHTENING TORQUE SPECIFICATION
| Reinforcement strut on cross connection and bumper bracket | ||
|---|---|---|
| Oval-head screw M8 | tightening torque | 19 Nm |
- Detach the air duct (1) at the lever (2) rearwards and fold upwards.
- Clip in the unfiltered-air grille (1) with the detents (2) .
Follow-up work
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to INSTALLING TOPPING AIR DUCT .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH COVERS .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .