Preparing New Part

NOTE: TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions

Mark new luggage compartment floor in accordance with severance cut on vehicle + 20 mm extra material and cut.
Slightly bend the flange surfaces (1) towards the inside.

Courtesy of BMW OF NORTH AMERICA, INC.
Adjust new part in conjunction with tail panel and secure.

Courtesy of BMW OF NORTH AMERICA, INC.
In area (1) , make 10 holes of Ø 4.2 mm for blind rivets.

Courtesy of BMW OF NORTH AMERICA, INC.
In area (1) , make 4 bores of 4.2 mm for blind rivets.
Remove new part and deburr holes.

Courtesy of BMW OF NORTH AMERICA, INC.
Prepare bonding surfaces.

Preparing the steel surface (used part and new part) for non-structural adhesive bond

Do not sand the bonding surface.
Do not sand the bonding surface down to the bare metal.
Clean coarse dirt from the bonding surfaces.
CONSUMABLE SPECIFICATION

Cleaning agent R2 500 ml 83190417324
Clean bonding surface. Adhere to the air drying time of 2 min!

CONSUMABLE SPECIFICATION

Cleaning agent R1

100 ml, Bottle

83192211217