Install Center Luggage Compartment Floor
NOTE:
Perform the steps on the left and right side.
- Pre-clean the bonding surface (1)
on the vehicle and on the new part with solvent cleaner R2.
CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean the bonding surface (1)
on the vehicle and on the new part with solvent cleaner R1.
CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K1 in area (1)
on the new part and the vehicle.
ADHESIVE SPECIFICATION
Body adhesive K1 195 ml 83190413015 - Pre-clean the bonding surface (1)
on the vehicle and on the new part with solvent cleaner R2.
CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean the bonding surface (1)
on the vehicle and on the new part with solvent cleaner R1.
CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K1 in area (1)
on the new part and the vehicle.
ADHESIVE SPECIFICATION
Body adhesive K1 195 ml 83190413015 NOTE: TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive. - Install the new parts and rivet them with blind rivets N1 (2)
and blind rivets N2 (3)
.
CONSUMABLE SPECIFICATION
Blind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm83190301414 CONSUMABLE SPECIFICATION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (4) . Consumable
- Rivet the new part in area (1)
with blind rivets N10 (2)
and blind rivets N1 (3)
.
CONSUMABLE SPECIFICATION
Blind rivet N10
Ø 6.5 mm; clamping area 10.8-12.8 mm83199144282 CONSUMABLE SPECIFICATION
Blind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm83190301414 - Weld the new part in area (1)
.
- Weld the new part in area (1)
.
- Weld the new part in area (1)
.
- Weld new parts in areas (1)
.
- Weld the new part in area (1) .