Install the side trim panel in the footwell at the left A-pillar
- Check the clips (3) for damage and replace if necessary.
- Position the side trim panel (2) and engage it in the clips (3) .
- Make sure that the side trim panel (2) is correctly fitted against edge protection.
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| A-pillar footwell side trim panel | ||
|---|---|---|
| screw | Tightening torque | 2.5 Nm |
- Install hood release lever (1) .
- Pull the hood release lever (1) to the rear.
- Install locking wedge (2) .
Follow-up work
- Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .