Installing wheel electronics
NOTE:
TECHNICAL INFORMATION
It is absolutely necessary to replace the tire valve to prevent leaks.
Before installing the tire valve: Clean the bore in the wheel rim thoroughly and deburr where required.
It is absolutely necessary to replace the tire valve to prevent leaks.
Before installing the tire valve: Clean the bore in the wheel rim thoroughly and deburr where required.
- Insert the valve insert (1) into the wheel electronics in the arrow direction.
- Fit the sealing ring (1) in the arrow direction.
- Ensure correct installation position.
The mark (1) on the sealing ring must point upwards.
- Insert the valve insert with the wheel electronics (1) into the cleaned bore in the rim.
The wheel electronics must rest on the rim.
- Replace the union nut (1).
Parts: Coupling nut
- Screw on the union nut (1) manually until it abuts.
- Press the wheel electronics evenly into the rim base.
- Tighten union nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Tire valve to wheel rim | ||
| Replace union nut. Tighten screw connection in one go. Do not retighten the screw connection. |
Tightening torque | 8 Nm |
- Make sure that the wheel electronics rests evenly on the rim even after tightening.