Installing the servomotor
NOTE:
TECHNICAL INFORMATION
Position the servomotor so that the gearing is aligned in an interlocking way.
Position the servomotor so that the gearing is aligned in an interlocking way.
- Position the servomotor (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Servomotor on rear axle differential | ||
| M6 | tightening torque | 9 Nm |
- Slide the holder (1) onto the servomotor (2) until the lock engages (arrow).
- Fasten the cable on holders (3).
- Connect connectors (1) and (2) and lock.
Follow-up work