Tightening the screw connection of the upper rear control arm to the rear axle support
- Slacken the screw (1) one revolution and tighten it. Counter support the nut with the standard tool (2) while doing so.
Standard tool: Ring wrench for hexagon head, cranked
Ring wrench for hexagon, offset
Ring wrench for hexagon, offset
TIGHTENING TORQUE SPECIFICATIONS
| Upper wishbone at front/rear to rear axle support | ||
| M12 Replace screw and nut. Tighten in NORMAL POSITION . |
Tightening via screw Tightening torque |
100 Nm |