Removing the wheel carrier on the left and right

Removing the wheel carrier 

• Tie up output shaft (1)  using special tool 2 413 317 .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mark the position of the eccentric of eccentric screw (3)  in relation to the wheel carrier in order to simplify the subsequent adjustment of the rear axle.
• Release nut (1)  .
• Remove the eccentric washer (2)  .
• Pull out eccentric screw (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Pull anti-roll bar link (1)  a little to the rear and pull out screw (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the screw (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Secure component against falling.
• Release the nuts (1)  and (2)  . If necessary, counter support at the Torx socket.
• Guide out and remove wheel carrier (3)  from the wishbones.

Courtesy of BMW OF NORTH AMERICA, INC.