Installing the wheel carrier on the left and right

NOTE: Perform the steps on the left and right side.

Install wheel carrier

Feed in and position the wheel carrier (3) at the wishbones.
Replace the nuts (1) and (2) .
Parts: Nut
Hand-tighten the nuts (1) and (2) . If necessary, counter support at the Torx socket.

Tighten nuts (1) and (2) . If necessary, counter support at the Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Upper wishbone at front/rear to wheel carrier
M14 Replace nut.	Tightening torque	165 Nm

Replace the screw (2) .
Parts: Screw
Insert the screw (2) and position the anti-roll bar link (1) on the wheel carrier.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1) .

TIGHTENING TORQUE SPECIFICATIONS

Rear anti-roll bar link to wheel carrier
M10 Replace screw.	Tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.

Replace the screw (1) .
Parts: Screw
Tighten screw (1) by hand.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1) .

TIGHTENING TORQUE SPECIFICATIONS

Front lower wishbone to rear axle support
M12 Replace screw.	Tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In order to tighten the screw connection with the torque wrench after adjustment work, the direction of insertion of the eccentric screw must be reversed.

Replace the eccentric screw (1) , the eccentric washer (2) and the nut (3) .
Parts: Eccentric screw, eccentric washer, nut

Courtesy of BMW OF NORTH AMERICA, INC.
The eccentric screw (1) must be inserted from the top.
Position eccentric washer (2) .
Hand-tighten the nut (3) . Turn the eccentric to the mark.
The threaded connection is tightened with the torque wrench only after the wheel alignment.
Release the special tool 2 413 317 from the output shaft (1) and remove it.

Courtesy of BMW OF NORTH AMERICA, INC.