Installing the air duct for coolant radiator
- Guide in air duct (2) and position it correctly.
- Mount the expanding rivets (1) .
- Secure the wiring harness with all the holders to air duct (2)
.
- Install cross connection (5) .
- Tighten the screws (4)
.TIGHTENING TORQUE SPECIFICATIONS
Cross connection at the top to rear cross connection M8x20 screw Tightening torque 28 Nm - Tighten the screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Cross connection, top M6x20 Tightening torque 11.8 Nm - Tighten the screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Cross connection at the top to the lock support Oval-head screw Tightening torque 28 Nm - Mount the expanding rivets (1) .
Follow-up work
- Refer to INSTALLING THE FRONT END .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
- Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to INSTALLING THE LEFT AND RIGHT HEADLIGHT .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .
- Refer to ADJUSTING HEADLIGHTS .