Install the actuator on the left hood hinge
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Feed in the actuator (1) at the guide pin (2) and slide to the back in arrow direction up to the stop.
- Replace the screw (3).
Parts: Screw
- Tighten down screw (3).TIGHTENING TORQUE SPECIFICATIONS
Actuator to engine compartment lid hinge M6x12 Replace screw. Tightening torque 8 Nm - Connect connectors (4) and lock.
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .