Installing camshaft position sensor of intake camshaft
- Check sealing ring (1) for damage, replace if necessary.
- Guide in and install camshaft position sensor (3) of the intake camshaft.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Camshaft position sensor to cylinder head cover | ||
|---|---|---|
| TS5x20 | Tightening torque | 4 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .