Install support for bumper cover at front bottom
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Thread in the support for the bumper cover at front bottom (2) and position.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Support for front bottom bumper cover to deformation element | ||
|---|---|---|
| Combination oval-head machine screw | Tightening torque | 10 Nm |
Follow-up work
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALL CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to ADJUSTING THE FRONT RADAR SENSOR (FRS) .